Advertisement
When the system has been disabled via the diagnostic tester, the TFT display displays the specific
message "TPMS inactive".
Simultaneously, the specific indicator light starts flashing and continues to flash for a maximum period of 90
seconds (determined by NTP), after which the indicator light remains lit continuously until normal
operating conditions are restored
Subsequently (or if the "Escape" function key is pressed during the display cycle), the screen disappears but
the warning light remains lit.
The TYRES screen is not recallable by the driver.
Tyre pressure sensor
The sensors are mounted to the wheel rim and secured by the inflation valve.
The sensor must be correctly fixed to the valve for the system to function.
ALWAYS replace with new components when REMOVING the TPMS sensor, complete with valve,
from the rim.
Replace the entire sensor-valve assembly even if only one of the components is damaged.
Detaching the tyre from the rim without due caution may cause irreparable damage to the sensor.
Removing the tyre pressure sensors
ALWAYS replace with new components when REMOVING the TPMS sensor, complete with valve,
from the rim.
The sealant liquid contained in puncture repair aerosols may damage the sensor. Always replace the
sensor if a tyre has been repaired with a puncture repair aerosol.
Replace the entire sensor-valve assembly even if only one of the components is damaged.
Remove the tyre (
D2.02).
Advertisement
