Advertisement
Press the relative button to lower the quarterlight
to approximately 10 mm from its upper travel
limit on the Rear Roof shell seal. Once in this
position, check that the quarterlight preload is
correct.
Check that the step between the Rear Roof shell
pillar and the quarterlight is 8.5 ± 1 mm.
If the value measured is incorrect, adjust as
follows.
Adjust the quarterlight preload by turning the
adjustment dowel with outer checknut located
on the bodyshell, behind the lower lateral trim
panel.
Holding the nut (1) still to prevent it from turning,
turn the adjuster dowel (2) to reach the
correct position.
Tightening the adjuster dowel decreases
quarterlight preload, loosening increases
quarterlight preload.
With the quarterlight completely raised, check,
from outside the vehicle, that the distance
between the quarterlight and the door window
is 12 ± 2 mm.
Advertisement
