Advertisement
Undo the six screws (75) fastening the axle shaft
to the differential flange, recovering the three
spacers (76).
Perform the procedure on both sides of the
vehicle.
Undo the nut (79) and remove the pin (80)
fastening the toe-in adjustment tie-rod from
the hub carrier, recovering the relevant
washers.
Support the weight of the rear suspension
adequately and undo the nut (81), removing
the relevant pin and recovering the washers.
Tilt the wheel module outward to detach the axle
shaft from the differential flange.
Perform the operations described previously on
both sides of the vehicle.
UP TO Assembly No. 85744
Remove the Bowden cables (82) from the
mounting bracket, removing the Seeger rings
indicated (red arrows).
Undo the screws (84) fastening the gearbox lock
releaser.
Release the Bowden cables (82), removing the
clamps indicated.
Remove the gearbox lock releaser (83),
complete with Bowden cables, from the
relevant gearbox lock release pin.
Advertisement
