Advertisement
C3.03
Draining clutch hydraulic system and filling with Shell DCT F-3 fluid
Draining Shell DCT F-3 hydraulic clutch system oil
Remove the rear flat undertray section (
E3.12).
Place a container under the plug indicated in the
figure to collect the oil.
Undo the plug (1) located at the bottom of the
gearbox housing.
ALWAYS dispose of liquids correctly in
accordance with applicable legislation.
Collect all liquids drained from the vehicle
systems in appropriate airtight containers,
then close the containers.
Drain the oil completely.
ONLY for vehicles WITHOUT single oil heat
exchanger
Remove the mounting bracket (3) for the clutch
hydraulic system oil pipes, undoing the
screws indicated.
Remove the clamps and the clamp (4) from the
bodyshell, then detach the delivery and return
unions (5) from the hydraulic clutch system oil
pipes.
ONLY for vehicles WITHOUT single oil heat
exchanger
To disconnect the clutch hydraulic system oil
pipes, turn the safety ring nut (14) to align the
notch on the ring nut with the pin (13).
Push the safety ring nut (14) towards the pin (13)
to release the pipes.
ALWAYS dispose of liquids correctly in
accordance with applicable legislation.
Collect all liquids drained from the vehicle
systems in appropriate airtight containers,
then close the containers.
Allow the liquid remaining in the clutch hydraulic
system oil pipes to drain completely.
Advertisement
