Advertisement
Refit the internal door window scraper seal (
Refit the door window (
Replacing the power window unit
Tightening torque
Fastening power window unit motor - door
Fastening upper fastener between power window
unit guides - door
Fastening lower fastener between power window
unit guides - door
The following procedure is for replacing the right hand power window unit.
The procedure for replacing the left hand power window unit is the same.
Remove the door window (
Disconnect the battery (
E3.08).
E3.08).
Nut
Screw
Nut
E3.08).
F2.01).
Carefully detach and remove the external
window scraper seal (A) from the relative
seat, starting from the rear end.
Replace the external window scraper seal (A).
Fit and insert the external window scraper seal
(A) in the relative seat, starting from the front
end.
Check that the profile of the external window
scraper seal (A) is straight.
Tighten the seven screws indicated fastening the
external window scraper seal (A) to the door
subframe.
Tightening torque
Screw
Nm
Class
4 Nm
Nm
Class
9.5 Nm
B
9.5 Nm
B
9.5 Nm
B
B
Advertisement
