Advertisement
Disconnect the connectors (58) of the injection
cable (42).
Detach the injection cable (42) from the chassis
by releasing the indicated clips.
Pull the left hand injection cable (42) upwards
out of its seat and place on top of the intake
manifold so that it does not hinder the
following operations.
Undo the screws indicated.
Move the heat shield (59) to the rear to allow
access to the transmission housing fasteners
on the transmission shaft.
Undo the six screws (60) fastening the
transmission shaft (61) to the gearbox.
Remove all the screws (60) and retrieve the
three shims (62).
Use a suitable tool to separate the transmission
shaft flange from the transmission housing.
Advertisement
