Advertisement
Fit the bumper (A) on the vehicle, fitting the two
lateral air intakes.
Hand tighten the upper centre screw fastening
the front bumper (A).
On both sides of the vehicle, hand tighten the
lateral centre screw fastening the front
bumper (A).
Check on both sides that the panel gap between
the front bumper (A) and the front fender (B)
is 1 mm (-0/+1).
Also check the panel alignment of the front
bumper (A) relative to the engine
compartment lid (C).
In the event of incorrect panel alignment
between the front bumper (A) and the front
fender (B) and/or with the engine
compartment lid (C), loosen the screws
tightened previously and adjust the front
bumper (A) to obtain the correct panel
alignment.
Tighten the seven upper screws indicated
fastening the front bumper (A).
Tightening torque
Screw
Refit the front seal (1).
If necessary, replace the double sided adhesive
strip fixing the seal (1) to the bumper.
Nm
Class
7.5 Nm
B
Advertisement
