Advertisement
Tightening torque
Fastening lateral mounting brackets for rear
bumper
Fastening lateral fastener for rear bumper
Fastening rear bumper
Connect the parking sensor connectors.
Fit the rear bumper, pressing on both sides to fasten to the respective lateral mounting brackets fixed to
the bodyshell.
Nut
Screw
Screw
For vehicles with parking camera
Connect and fasten the cable (3).
Hand tighten the screws indicated.
If the rear bumper (A) has been replaced, check,
on both sides of the vehicle, that the panel
gap between the rear bumper (A) and the
rear fender (B) is 1 mm (-0/+1).
If the panel alignment between the rear bumper
(A) and the rear fender (B) is incorrect,
remove the rear bumper from the vehicle,
pulling from both sides, and carry out the
following procedure.
Nm
Class
4.5 Nm
B
7 Nm
B
7.5 Nm
B
Advertisement
