Advertisement
Check that the yellow reference markings are
correctly aligned: the markings on the stud
bolts and the markings on the Flanbloc
eyebolts must be aligned.
Remove the yellow reference markings made
during removal.
Using an indelible red marker pen or paint, make
reference markings on the stud bolts and
relative nuts and the eyebolts of the Flanblocs
fastening the lower arm.
Whenever the nut and/or the screw fastening
the lower rear suspension arm is or are
removed, ALWAYS REPLACE BOTH the
nut and the screw with new parts when
reassembling.
Align the lower arm with the link and the hub
carrier then fit the new screw (3) in the
relative holes.
Fit the relative washer and tighten the new nut
(2) fastening the screw (3).
Tightening torque
Nut
Attach the tie-rod (1) for the NRRPS motion
sensor onto the lower arm (A).
Magnetorheological shock absorbers (optional)
only.
Nm
Class
205 Nm
A
Advertisement
