Advertisement
Pressing into place by hand, fit the rubber bushes on the stabiliser bar in the same position and orientation
noted during disassembly.
Apply a uniform layer of grease DuPont
Lubricants Krytox® 205 GPL Standard
Grade Grease on the surfaces of shoulder
bushings in contact with the rubber bushes.
Apply 1 ml of grease MOLYKOTE PG21 evenly
to the entire inner surface of the bushings in
contact with the stabiliser bar.
FROM Assembly No. 94496, spread 1 ml of
grease DuPont Lubricants Krytox® 205
GPL Standard Grade Grease evenly over
the entire inner surfaces of the bushings in
contact with the stabiliser bar.
Using a cloth moistened with heptane,
thoroughly clean and degrease the outer
surface of the rubber bushes and the inner
surface of the bush bracket (5).
Fit the rear stabiliser bar (A) in its relative seat
on the rear subframe, ensuring that the
reference dot is on the left-hand side.
Fasten the stabiliser bar by tightening the nuts
(4) fastening the bushing bracket (5) to the
rear stabiliser bar (A).
Repeat the procedure on the left hand
suspension.
Tightening torque
Nut
Nm
Class
30 Nm
A
Advertisement
