Advertisement
Undo the screws (46) fastening the brake calliper
(45) to the hub carrier.
Perform the procedure on both sides of the
vehicle.
Leaving the brake calliper (45) connected to the
system, set it down taking care not to tauten
the cables and oil pipes.
Perform the procedure on both sides of the
vehicle.
Undo the screws indicated.
Move the heat shield (Y) forwards to allow
access to the screws fastening the driveshaft
to the gearbox.
Undo the six screws (47) fastening the
transmission shaft (49) to the gearbox (50),
recovering the three shims (48).
Advertisement
