Advertisement
Refit the rear flat undertray section (
Draining the gear oil system for mechanical gearbox
The gear oil must be changed at the intervals specified in the MAINTENANCE SCHEDULE.
Remove the rear flat undertray section (
Fit and fasten the mounting bracket (3),
tightening the indicated screws.
Fit the shield (1) and fasten the EPB cable (2) by
tightening the indicated screws.
E3.12).
E3.12).
Place a container under the plug indicated in the
figure to collect the oil.
Undo the plug (1) located at the bottom of the
gearbox housing.
ALWAYS dispose of liquids correctly in
Collect all liquids drained from the vehicle
Drain the oil completely.
Remove the gear oil pipe mounting bracket (3),
undoing the screws indicated.
Remove the pipe retainer clamp (4) from the
bodyshell.
Disconnect the gear oil pipe unions (5).
accordance with applicable legislation.
systems in appropriate airtight containers,
then close the containers.
Advertisement
