Advertisement
With the RHT in Coupé configuration, open and close the quarterlight completely a few times, checking
that it rolls without resistance and seals correctly, then check the adjustment values again.
Bring the RHT into Spider configuration and raise
the door window and relative quarterlight.
Check that the adjacent corners of the door
window and the quarterlight are aligned
correctly as shown in the photo aside when in
Spider configuration.
If the windows are not correctly aligned, proceed
as follows:
Remove the door panel (
Lift the internal window scraper seal (17) and
adjust the door window height in Spider
configuration with the travel limiter screw (18)
located in the door gap.
Tighten the travel limiter screw to reduce the
window height, undo the screw to increase
the height.
Note that one turn of the adjuster screw
equates to 1 mm in height along the "Z"
axis.
Fit the internal window scraper seal (17) onto the
respective rib on the door and check
alignment again.
Once adjustment is complete, keep the adjuster
dowel (2) immobilised and tighten the nut (1).
Tightening torque
Nut
E3.08).
Nm
Class
9 Nm
B
Advertisement
