Advertisement
Installing the RETROFIT KIT FOR ENGINES WITH SINGLE HEAT EXCHANGER, Part No. 270156
Tightening torque
Fastening the flexible water delivery hose
Fastening rubber lined clip
Products to use: Loctite 242
Fastening the rigid water delivery pipe
The kit consists of the following components:
5 x TCEI M6x18 screws with washer Part No. 231617;
2 x M6 riveting nuts Part No. 248153;
Toroid O-ring Part No. 264447;
Rigid water delivery pipe Part No. 266247;
Flexible water delivery hose to engine compartment Part No. 266394.
Unscrew and retrieve the union (C) from the old
engine.
Tighten the union (C) onto the new engine to a
depth of 7 (+0 / -2) mm.
Connect the pipe (D) to the union (C).
Tighten the hose clamp (1).
Screw (Part No. 231617)
Screw
Screw (Part No. 231617)
Fit the toroid O-ring in the relative seat on the
pipe (A).
Fit the pipe (A).
Tighten the indicated screws supplied in the kit.
Tightening torque
Screw (Part No. 231617)
Nm
Class
8 Nm
B
8 Nm
B
8 Nm
B
Nm
Class
8 Nm
B
Advertisement
