Advertisement
Fit the upper plates (1) of the brackets
fastening the anti-tipping safety
retainers
(AV
8183) onto the safety
extensions on the car lift runways.
The anti-tipping safety retainers must be as
close as possible to the vehicle lift runway
safety extensions, as shown in the image
aside.
Fit the lower plates (2) of the brackets fastening
the anti-tipping safety retainers on the safety
extensions under the car lift runways.
Tighten the four screws fastening the upper (1)
and lower plates (2) to the safety extensions
on the car lift runways.
Check that the brackets are correctly positioned
on the car lift runway safety extensions, so
that the anti-tipping safety retainers engage
correctly with the relative fastener slots on the
vehicle during lifting.
Loosen the screws (3) fastening the positioning
levers (6).
Holding the sleeves (4) to prevent them from
turning, rotate and unscrew the ring nuts (5),
together with the positioning levers (6), until
the head of the eccentric pins (7) protrudes in
the correct position for attaching to the
vehicle.
Note that the rear right hand fastener slot is
parallel to the longitudinal axis of the
vehicle, the front right hand fastener slot is
perpendicular to the longitudinal axis of the
vehicle, the rear left hand fastener slot is
perpendicular to the longitudinal axis of the
vehicle and the front left hand fastener slot
is parallel to the longitudinal axis of the
vehicle.
Preventing the ring nuts from turning (5), hand
tighten the sleeves (4).
Turn the positioning levers (6) until the eccentric
pin head (7) retracts into the correct position
to allow the insertion of the anti-tipping safety
retainers into the relative fastener slots.
Tighten the screws (3) fastening the positioning
levers (6).
(AV
8184)
Advertisement
