Advertisement
Using a delible yellow marker pen or paint, make
reference markings on the stud bolts and
relative nuts and the eyebolts of the Flanblocs
fastening the lower arm.
Undo the tie-rod ball stud (4) on the lower arm.
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the four nuts indicated fastening
the lower arm (A) to the chassis, retrieving
the four shims (7), in the following order: (a),
(b), (c), (d).
UP TO Assembly No. 98014, fork type spacers
(7) are used.
FROM Assembly No. 98015, plate type spacers
(7) are used.
Check that the yellow reference markings are
correctly aligned: the marking on the stud
bolts and the marking on the Flanbloc
eyebolts must be aligned.
Only the nut must turn, the stud bolt must
remain in its original position.
If the markings on the stud bolts and Flanbloc
eyebolts are not correctly aligned after
loosening the arm fastener nuts (even if only
on one stud bolt), a ROL (Red On Line) must
be opened, attaching adequate photographic
documentation, and contact the Ferrari Help
Desk.
If the markings on the stud bolts and Flanbloc
eyebolts are correctly aligned after loosening
the arm fastener nuts, completely undo and
remove the four arm fastener nuts in the
order given for the previous operation.
Advertisement
