Advertisement
B6.04
Engine coolant pressure switch/thermostat
Removing the pressure switch/thermostat
After loosening or removal, the Caillau Visa hose clamps must be replaced with Mikalor worm drive
hose clamps, following the instructions given in Technical Information 2054 of December 2012.
The switch is located at the front of the engine.
Drain the cooling system (
Remove the battery (
Refitting the pressure switch/thermostat
Tightening torque
Fastening pressure switch/thermostat
After loosening or removal, the Caillau Visa hose clamps must be replaced with Mikalor worm drive
hose clamps, following the instructions given in Technical Information 2054 of December 2012.
A3.07).
F2.01).
Loosen the clamp (1) and detach the delivery
pipe from the pressure switch/thermostat (A).
From above, undo the three screws (2) and
remove the pressure switch/thermostat (A),
easing out from the battery seat.
Screw
Nm
Class
11 Nm
B
Advertisement
