Advertisement
D3.08
Brake servo - Pump
Removing the brake servo
Remove the engine compartment cosmetic shields (
Remove the left hand cosmetic underwindscreen shield.
Remove the brake fluid tank (
Remove the windscreen wiper linkage (
Remove the driver side underdashboard trim panel (
D3.02).
E3.09).
E3.13).
E4.02).
Open the three fastener clips indicated.
Some brake fluid may leak when detaching
the unions from the master brake
cylinder; ensure that the oil does not
come into contact with surrounding parts.
Hydraulic brake fluid is corrosive.
Contact with brake fluid may cause severe
injury or damage to painted parts of the
vehicle.
In the event of skin contact with fluid, wash
the respective part of the body
immediately with plenty of water.
In the event of contact between the fluid and
painted parts of the vehicle, wash and dry
the respective areas immediately.
Undo the two unions (1) on the master brake
cylinder.
Move the pipes as far away as possible from the
master brake cylinder, taking care not to bend
or twist them, so that they do not impede the
subsequent procedures.
Detach the vacuum pipe (2) from the brake servo
(A).
Advertisement
