Advertisement
Tightening torque
Oxygen sensor - catalytic converter
Do not clean or apply grease on the oxygen sensor thread.
Do not use solvents or thread locking products as they may impede correct sensor operation.
The oxygen sensor thread is pre-lubricated by the manufacturer with a specific product.
Whenever a sensor is replaced, the self-acquired parameters must be deleted from the ECU memory.
Located at the front of the right catalytic converter.
Disconnect the battery (
Remove the central flat undertray section (
Remove the front wheelhouses (
Remove the right one.
Refit the front wheelhouses (
Refit the central flat undertray section (
Connect the battery (
Replacing the rear right oxygen sensor
Tightening torque
Oxygen sensor - catalytic converter
Do not clean or apply grease on the oxygen sensor thread.
Do not use solvents or thread locking products as they may impede correct sensor operation.
The oxygen sensor thread is pre-lubricated by the manufacturer with a specific product.
F2.01).
E3.05).
E3.05).
E3.12).
F2.01).
Oxygen sensor
E3.12).
Detach the connector (1).
Detach the cable from the clamp (2).
Undo the front oxygen sensor (C) from the
catalytic converter and replace.
Fit the front oxygen sensor (C) onto the catalytic
converter and tighten it.
Tightening torque
Oxygen sensor
Attach the cable using the clamp (2).
Connect the connector (1).
Oxygen sensor
Nm
Class
50 Nm
B
Nm
Class
50 Nm
Nm
Class
50 Nm
B
B
Advertisement
