Advertisement
Preload
Remove both waterproof liner sheets (1).
Press the relative button to lower the power
window and allow access to the relative
fasteners.
Loosen the two screws (2) fastening the door
window to the relative mounting brackets.
Manually correct the position of the door window.
Once adjustment is complete, tighten the screws
(2).
Tightening torque
Screw
With the door partially closed and the window
completely raised and in contact with the
upper seal, check that the gap between the
rear edge of the door (near the handle) and
the fender is between 8 and 11 mm.
If the distance measured is within the range
specified, refit any components removed in
order to make the aforementioned
adjustments as follows.
If the distance measured is not within the range
specified, adjust as follows.
Nm
Class
9.5 Nm
B
Advertisement
