Advertisement
Attach the cable grommet (6) onto the relative
mounting bracket.
Slide connector (5) of brake pad wear sensor
under ABS sensor cable, connect it, and
attach it to the relative mounting bracket.
Connect connector (4) of ABS sensor, and attach
it to the relative mounting bracket.
Check that the indicated clip is positioned at 50 -
60 mm from cable grommet (6).
Connect ground cable to the indicated clip.
FROM Assembly No. 103179 (consult the Spare
Parts Catalogue to identify vehicles not
affected by modification)
Fit the union (12) for the brake fluid hose onto
the relevant mounting bracket.
Refit the clip (11) fastening the union (12) for the
brake fluid hose onto the relative mounting
bracket.
Tighten the brake fluid hose union (10).
Tightening torque
M10 union
Connect and fasten the connector (4) for the
ABS sensor.
Attach the cable grommet (6) onto the relative
mounting bracket.
FROM Assembly No. 103179 (consult the Spare
Parts Catalogue to identify vehicles not
affected by modification)
Secure the cable to the indicated clip.
Fit and tighten new cable ties as indicated.
Nm
Class
16 Nm
B
Advertisement
