Checking alignment along "Z" axis
Check that a 3 mm shim can be inserted between the surface of
the vibration damper (1) and the base of the head of the rear
pin of the silencer.
The protrusion of the pins indicated must be ≥ 3 mm.
Perform the procedure on both sides of the vehicle.
Check that a 3 mm shim can be inserted between the surface of
the vibration damper (1) and the base of the head of the
lateral pin of the silencer.
The protrusion of the pins indicated must be ≥ 3 mm.
Perform the procedure on both sides of the vehicle.
On both sides of the exhaust system, measure the distance
between the central silencer (A) and the cross member of the
front removable subframe below the silencer
The difference between the two measurements must not
exceed 6 mm.