Ferrari California Workshop Manual page 553

Hide thumbs Also See for California:

Refitting the wheels

Tightening torque

Before performing any maintenance on vehicles with the Stop&Start system, turn the ignition key to 0 (Key-

Before performing any maintenance procedures requiring the ignition key to be in position II on vehicles with

the Stop&Start system, deactivate the Stop&Start system with the relative button, ensuring that the

specific icon and the message "Stop&Start OFF" are shown on the TFT display, and that the LED on the

on/off button itself is off.

Failure to do so may result in serious injury to persons working on the vehicle and in the vicinity of the

vehicle in the event of the engine unexpectedly starting.

Use tools very carefully in order to prevent damaging the painted surfaces of the wheel rim.

Tyres that have been fitted for over 3 years must be checked to verify they are still suitable for use.

Tyre replacement is recommend after 4 years of normal use. Frequent use in maximum load conditions and

at high temperatures may lead to premature deterioration.

Pretightening of stud bolt

Fit the complete wheel, inserting the locator pin

into its seat on the wheel rim.

Hand tighten the stud bolt opposite the pin first,

then the others. Pretighten the stud bolts in a

crossed pattern.

Tightening torque

Pretightening of stud bolt

Lower the vehicle and tighten the stud bolts

definitively (1).

Tightening torque