Advertisement
Connect the battery (
Check and adjust door closure (
Checking and adjusting door closure
Tightening torque
Fastening door striker plate
The door striker plate must be checked and adjusted with the door window completely raised.
F2.01).
E3.08).
Fit the complete door (A) on the hinges.
Tighten the two screws (3) fastening the door to
the hinges.
Tightening torque
Screw
Tighten the screw (2) fastening the tie-rod.
Tightening torque
Screw
Connect the connector (1).
Screw (pretightening)
Screw
Visually check that the door is flush with the rear
fender.
If the door does not close flush with the fender,
adjust the door striker plate as follows.
Nm
Class
18 Nm
Nm
Class
30 Nm
Nm
Class
18.4 Nm
B
23 Nm
B
B
B
Advertisement
