Advertisement
A3.02
Inspecting oil level and replacing Shell Transaxle 75W-90 GL5 gear oil
Check level of Shell Transaxle 75W-90 GL5 gear oil (ONLY for vehicles WITHOUT single oil heat
exchanger)
Tightening torque
Gear oil drain/filler plug - GL differential
The following procedures must be carried out exactly as described to ensure that the hydraulics are
proper lubricated and function correctly.
To check the gear oil level correctly, carry out the following procedures precisely as described.
Remove the rear flat undertray diffuser (
Ensure that the vehicle is NOT on a gradient.
Start the engine and run at idle speed.
Select reverse R and hold the brake pedal.
Check that the clutch system ATF fluid temperature DOES NOT exceed 40 °C.
Check that the engine coolant temperature is between 40 and 50 °C.
Plug
E3.12).
CAUTION
HOT OIL may be released: use adequate
protection.
Undo the threaded plug (1) located on the rear
surface of the transmission, and check the
level: the fluid must reach the edge of the
hole from which the plug was removed, on
the limit of overflowing.
Nm
Class
25 Nm
B
Advertisement
