Advertisement
Clean the seat of the filter on the gearbox to
remove any contaminants.
Fit a new O-ring on the oil filter (6), lubricating
with the specified gearbox oil.
Fit the oil filter (6) in its seat, after lubricating the
seat with the specified oil.
Tighten the fastener screws.
Tightening torque
Screw
Clean the unions to be connected thoroughly
with a suitable degreaser that does not leave
residue.
Connect the gear oil pipe unions. Follow the
instructions given below to ensure proper
connection:
ensure that the notch on the safety ring nut (14)
is aligned with the pin (13);
connect the male union and turn the safety ring
nut (14) so that it is no longer aligned with the
pin (13);
ALWAYS ensure that the pipe union is effectively
connected.
Connect the unions (5) for the gearbox oil pipes
and fasten the clamp (4) to the bodyshell.
Fasten the mounting bracket (3) for the gear oil
pipes, by tightening the screws indicated with
relative washers.
Tightening torque
Screw
Nm
Class
5 Nm
C
Nm
Class
20 Nm
B
Advertisement
