Advertisement
Position the two washers onto the relative stud
bolts and the upper arm (A) of rear
suspension into the relative seat.
Fit the pin (1) in the relevant seat.
Holding the pin (1) still, fit the relevant washers
and pretighten then tighten the nut (2).
Tightening torque
Nut
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm
fastener nuts, complete with relative
washers, each time they are removed.
Replacement is NOT necessary if the nuts
are loosened only.
Tighten the two nuts indicated fastening the
upper arm (E) to the chassis.
Tightening torque
Nut (pretightening)
Nut
Check that the yellow reference markings are
correctly aligned: the markings on the stud
bolts and the markings on the Flanbloc
eyebolts must be aligned.
Nm
Class
90 Nm
A
Nm
Class
25 Nm
A
60 Nm
A
Advertisement
