Advertisement
Replacing the belt
Remove the A.C. compressor - power steering pump - alternator drive belt (
Replace the belt.
Refit the A.C. compressor - power steering pump - alternator drive belt (
Fit the new belt.
Check the tension again as described previously.
If the tension value measured is still lower than the specified value, replace the belt tensioner as
described below.
Replacing the belt tensioner
Remove the A.C. compressor - power steering pump - alternator drive belt (
(Place )the frequency probe of the tension meter
1 (95978151) at the mid point of the lower
section of the belt, but without touching the
belt itself.
Tap the belt with a suitable tool near the tension
probe (1) and check that the value displayed
by the meter is 155 ± 10 Hz.
If the tension value measured is lower than the
specified value, replace the belt as
described below.
If the belt has been replaced recently, replace
the belt tensioner as described below.
A3.12).
Undo the screw (2) and remove the complete
belt tensioner (3).
A3.12).
A3.12).
Advertisement
