Advertisement
Refit the rear flat undertray section (
Connect the battery (
Fill and bleed the brake system (
Check the vehicle set-up (
Calibrate the EPB electric parking brake (
This procedure must only be performed if, at Key-ON, the NPB parking brake node identifies a fault,
indicated on the instrument panel and on the TFT display by the specific warning lamps, and with
error C155A on the NPB (EPB calibration error) and error C1313 on the NFR (parking brake
error).
E3.12).
F2.01).
D3.10).
D4.07).
D3.07).
FROM Assembly No. 103179 (consult the Spare
Parts Catalogue to identify vehicles not
affected by modification)
Insert the brake fluid hose (11) into the relevant
mounting bracket.
Tighten the brake fluid hose union (10).
Tightening torque
M12 Union
Refit the clip (9) fastening the union for the brake
fluid hose (11) onto the relevant mounting
bracket.
Fit a new cable tie (5) for retaining cables.
Attach the cable grommet (4) onto the relative
mounting bracket.
Connect the connector (2) for the brake pad
wear sensor.
Connect the connector (3) for the ABS sensor.
Attach the tie-rod (1) for the NRRPS motion
sensor onto the lower arm.
Nm
Class
16 Nm
B
Advertisement
