Advertisement
Tighten the six screws (75) fastening the axle
shaft to the differential flange, after fitting the
three shims (76).
Repeat the three previous operations for the
left hand rear suspension.
Tightening torque
Screw
Tighten the screw (89) fastening the gearbox-
rear removable subframe ground braid (90).
Tightening torque
Screw
ONLY for vehicles WITHOUT single oil heat
exchanger
Clean the area surrounding the ATF pipe
fastening points thoroughly with a suitable
degreaser that does not leave residue.
Place absorbent paper under the plugs to collect
any oil spillage.
Remove the plugs installed previously.
Remove the ATF delivery and return pipes and,
after replacing and lubricating the O-rings,
insert them in suitable seats.
Fit the ATF pipe retainer fork (74) and fasten
onto the unions by tightening the screw (73).
Tightening torque
Screw
Fasten the ATF pipes (72) onto the gearbox as
originally installed, fitting and fastening the
clamp with the nut indicated.
Nm
Class
78 Nm
A
Nm
Class
18 Nm
B
Nm
Class
20 Nm
A
Advertisement
