Advertisement
Remove the complete rear suspension assembly from the vehicle, retrieving the washers from the upper
arm stud bolts.
Detach the tie-rod (15) for the NRRPS motion
sensor from the lower arm (F).
Magnetorheological shock absorbers (optional)
only.
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the indicated nuts fastening the
lower arm (F) to the chassis, retrieving the
shims (16), in the following order: (a), (b), (c),
(d).
UP TO Assembly No. 98014, fork type spacers
(16) are used.
FROM Assembly No. 98015, plate type spacers
(16) are used.
Check that the yellow reference markings are
correctly aligned: the marking on the threaded
rods and the marking on the Flanbloc
eyebolts must be aligned.
Only the nut must turn, the threaded rod must
remain in its original position.
If the markings on the threaded rods and
Flanbloc eyebolts are not correctly aligned
after loosening the arm fastener nuts (even if
only on one threaded rod), a ROL (Red On
Line) must be opened, attaching adequate
photographic documentation, and contact the
Ferrari Help Desk.
If the markings on the threaded rods and
Flanbloc eyebolts are correctly aligned after
loosening the arm fastener nuts, completely
undo and remove the arm fastener nuts in the
order given for the previous operation.
Check again that the yellow reference markings
are correctly aligned: the markings on the
threaded rods and the markings on the
Flanbloc eyebolts must be aligned.
Advertisement
