Advertisement
Lowering the vehicle with anti-tipping safety retainers
The following procedure is for lowering the vehicle and subsequently removing the vehicle anti-tipping safety
retainers
(AV
8183) from the two post vehicle lift and removing the anti-tipping safety retainer fastener
brackets
(AV
8184), when using a runway type car lift.
Two post vehicle lift
Working carefully and ensuring that the anti-
tipping safety retainers are correctly aligned
with the respective fastener slots on the
vehicle, raise the vehicle lift runways until the
anti-tipping safety retainers engage in the
respective fastener slots.
Lift the vehicle slightly off the ground and check
that it is stable.
Loosen the screws (3) fastening the positioning
levers (6).
Turn the positioning levers (6) by 180°.
Unscrew the positioning levers (6).
Completely tighten the screws (3) fastening the
positioning levers (6).
Raise the vehicle lift runways until the car is the
desired height from the ground.
Lower the vehicle lift arms until the car is the
desired height from the ground.
Loosen the screws (9) fastening the positioning
levers (7).
Tighten the positioning levers (7).
Turn the positioning levers (7) by 180°.
Tighten the screws (9) fastening the positioning
levers (7).
Carefully lower the arms of the vehicle lift to
gently set the vehicle on the ground, ensuring
that the anti-tipping safety retainers withdraw
completely and without impediment from the
respective fastener slots on the vehicle.
Without allowing the screws (9) fastening the
positioning levers (7) to come into contact
with the floor, as this may damage the anti-
tipping safety retainers, lower the vehicle lift
arms completely.
Advertisement
