Advertisement
Fit the two front heat shields on the exhaust extensions as originally installed.
Never reuse exhaust system clamps and gaskets that have been subjected to operating temperature.
Always replace with new components.
Only new exhaust system clamps and gaskets may be removed and refitted for adjustment purposes
during initial installation.
Fit new Torx clamps on the front of the exhaust extensions.
Fit and fasten the two lower heat shields (67)
and (68) onto the rear removable gearbox
subframe, by tightening the screws indicated.
Tightening torque
Nut
Apply an even layer (93) approximately 15 mm
wide of HOLTS FIREGUM sealant paste
onto the mating surfaces of both of the rear
pipes of the central silencer with the exhaust
extensions.
Fill the notches (94) in both connecting
endpieces of the exhaust extensions with
HOLTS FIREGUM sealant paste.
Tighten the pins
(AV
for fastening the subframe to the vehicle
chassis.
Nm
9 Nm
8351) into the M12 holes
Class
B
Advertisement
