Advertisement
Refit the centre silencer (
B7.04).
Fit the three shims (6), then snug and
subsequently fully tighten the six screws (5)
fastening the transmission shaft (A) to the
transmission housing shaft.
Proceed in a crossed pattern when both
snugging and tightening the screws to
torque.
Tighten the screws to the definitive torque with
a control angle of 90°.
Tightening torque
Screw with control angle of 90°
Fit the three shims (4), then snug and
subsequently fully tighten the six screws (3)
fastening the transmission shaft (A) to the
gearbox.
Proceed in a crossed pattern when both
snugging and tightening the screws to
torque.
Tighten the screws to the definitive torque with
a control angle of 90°.
Tightening torque
Screw with control angle of 90°
Fit the heat shield (1) in the relative mounting
and fasten by tightening the screws (2).
Nm
Class
60 Nm
A
Nm
Class
60 Nm
A
Advertisement
