Advertisement
Remove the yellow reference markings made
during removal.
Using an indelible red marker pen or paint, make
reference markings on the threaded rods and
relative nuts and the eyebolts of the Flanblocs
fastening the lower arm.
Tighten the nut indicated fastening the stabiliser
bar (D) to the spherical tie-rod.
Tightening torque
Nut
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm
fastener nuts, complete with relative
washers, each time they are removed.
Replacement is NOT necessary if the nuts
are loosened only.
Tighten the indicated nuts fastening the toe-in tie-
rod (C) to the chassis.
Tightening torque
Nut (pretightening)
Nut
Nm
Class
50 Nm
B
Nm
Class
25 Nm
A
60 Nm
A
Advertisement
