Advertisement
Thoroughly clean the mating surface of the oil-
water heat exchanger (A) in contact with the
gasket.
Fit the oil-water heat exchanger (A) in the
relative housing.
Fit the bracket (7).
Fit and snug the indicated screws, using the
marks made during removal as reference as
the screws are not all of equal length.
Tighten the screws indicated.
Tightening torque
Screw
Fasten the connectors (5) onto the mounting
bracket, using the marks made during
removal as reference.
Lay out and fasten the knock sensor cables,
closing the indicated clamps.
Fit and fasten the water vent pipe (8), tightening
the indicated union.
Tightening torque
Union
Nm
Class
10 Nm
B
Nm
Class
10 Nm
B
Advertisement
