Advertisement
Using a delible yellow marker pen or paint, make
reference markings on the stud bolts and
relative nuts and the eyebolts of the Flanblocs
fastening the upper arm.
Detach the tie-rod for the NRRPS motion sensor
(2) from the upper arm (B).
Magnetorheological shock absorbers (optional)
only.
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the indicated nuts fastening the
upper arm (B) in the following order: (a), (b),
(c), (d).
Move the shock absorber aside to facilitate the
operation.
Check that the yellow reference markings are
correctly aligned: the marking on the stud
bolts and the marking on the Flanbloc
eyebolts must be aligned.
If the markings on the stud bolts and eyebolts
are not correctly aligned after loosening the
arm fastener nuts (even if only on one stud
bolt), a ROL (Red On Line) must be opened,
attaching adequate photographic
documentation, and contact the Ferrari Help
Desk.
If the markings on the stud bolts and eyebolts
are correctly aligned after loosening the arm
fastener nuts, completely undo and remove
the arm fastener nuts in the order given for
the previous operation.
Move the shock absorber aside to facilitate the
operation.
Advertisement
