Advertisement
Clean the mating surfaces on the intake manifold
and the cylinder heads thoroughly, and install
the two new gaskets (8).
Fasten the low pressure fuel line (7) onto the
rear of the previously removed intake
manifold, closing the plastic clip (6).
Take particular care when fitting the intake
manifold. Locating the manifold
incorrectly may deform and compromise
the tightness of the gaskets, causing
the "Engine diagnostic system (EOBD)"
warning light to illuminate.
Fit the intake manifold in its relative seat on the
locator bushings, taking care not to crush any
cables or pipes.
Fasten the intake manifold (A) on the left hand
cylinder bank, by tightening the eight screws
with relative washers.
Note that the photo was taken with all
components not involved in the procedure
removed to illustrate the operation more
clearly.
Tightening torque
Screw
Nm
Class
10 Nm
B
Advertisement
