Advertisement
Check that the yellow reference markings are
correctly aligned: the markings on the
threaded rods and the markings on the
eyebolts must be aligned.
Remove the yellow reference markings made
during removal.
Using an indelible red marker pen or paint, make
reference markings on the threaded rods and
the relevant nuts and eyebolts fastening the
lower arm.
Tighten the indicated screws fastening the shock
absorber (B) to the chassis.
Tighten in a crossed pattern.
Tightening torque
Screw (pretightening)
Screw
Connect the connector (14) to the shock
absorber (B).
Magnetorheological shock absorbers (optional)
only.
Nm
Class
10 Nm
A
30 Nm
A
Advertisement
