Advertisement
Refit the front wheelhouses (
E3.05).
ONLY for vehicles WITHOUT single oil heat
After replacing the relative seals, tighten the
screws (20) fastening the AC pipes (21) to the
condenser.
Tightening torque
Screw
Connect the radiator assembly connector (14)
and hand tighten the nut (15), fastening the
ground cable (16).
exchanger
Connect the clutch hydraulic oil system pipe
unions. Follow the instructions given below to
ensure proper connection:
ensure that the notch on the safety ring nut (12)
is aligned with the pin (13);
connect the male union and turn the safety ring
nut (12) so that it is no longer aligned with the
pin (13);
ALWAYS ensure that the pipe union is effectively
connected.
Nm
Class
9 Nm
B
Advertisement
