Advertisement
Do not clean or apply grease on the oxygen sensor thread.
Do not use solvents or thread locking products as they may impede correct sensor operation.
The oxygen sensor thread is pre-lubricated by the manufacturer with a specific product.
Whenever a sensor is replaced, the self-acquired parameters must be deleted from the ECU memory.
Located at the rear of the left catalytic converter.
Disconnect the battery (
Remove the central flat undertray section (
Remove the front wheelhouses (
Remove the left one.
F2.01).
E3.12).
E3.05).
Detach the connector (1).
Cut the plastic clamp indicated.
Detach the cable from the clamp (2).
Detach the cable from the clamp (3).
Advertisement
