Advertisement
Check that the yellow reference markings are
correctly aligned: the marking on the threaded
rods and the marking on the eyebolts must be
aligned.
Only the nut must turn, the threaded rod must
remain in its original position.
If the markings on the threaded rods and
eyebolts are not correctly aligned after
loosening the toe-in tie rod fastener nuts
(even if only on one threaded rod), a ROL
(Red On Line) must be opened, attaching
adequate photographic documentation, and
contact the Ferrari Help Desk.
If the markings on the threaded rods and
eyebolts are correctly aligned after loosening
the toe-in tie-rod fastener nuts, completely
undo and remove the toe-in tie-rod fastener
nuts in the order given for the previous
operation.
Check again that the yellow reference markings
are correctly aligned: the markings on the
threaded rods and the markings on the
eyebolts must be aligned.
Using a delible yellow marker pen or paint, make
reference markings on the threaded rods and
relative nuts and the eyebolts of the Flanblocs
fastening the upper arm.
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the indicated nuts fastening the
upper arm (E) to the chassis.
Advertisement
