Advertisement
C3.02
DCT gearbox clutch hydraulic oil system radiator (for vehicles WITHOUT
Removing the clutch hydraulic system oil radiator
The following system was installed UP TO Assembly No. 90608, and has been replaced by the new single oil
heat exchanger system.
Fit the A.C. condenser on the left of the radiator assembly.
Remove the engine air duct (
Remove the rear flat undertray section (
single oil heat exchanger)
B4.02).
E3.12).
Remove the mounting bracket (6) for the
hydraulic clutch system oil pipes, by undoing
the screws (7).
Remove the clamps (8) and (12), by undoing the
screws (9).
Remove the pipes from the mounting bracket
(10) and detach the delivery and return
unions (11).
To disconnect the clutch hydraulic system oil
pipes, turn the safety ring nut (14) to align the
notch on the ring nut with the pin (12).
Push the safety ring nut (14) towards the pin (13)
to release the pipes.
ALWAYS dispose of liquids correctly in
accordance with applicable legislation.
Collect all liquids drained from the vehicle
systems in appropriate airtight containers,
then close the containers.
Allow the liquid remaining in the clutch hydraulic
system oil pipes to drain completely.
Advertisement
