Ferrari California Workshop Manual page 708

Hide thumbs Also See for California:

ONLY for vehicles WITHOUT single oil heat exchanger

Note the respective orientation and positions of the rubber bushes and bar.

Remove the rear stabiliser bar from the vehicle, easing it out through the gap between the exhaust

extensions and the silencers.

ONLY for vehicles WITH single oil heat exchanger

Note the respective orientation and positions of the rubber bushes and bar.

Remove the rear stabiliser bar from the vehicle, pulling it backwards over the single oil heat exchanger to

the rear side.

Note the respective orientation and positions of the rubber bushes and bar, then remove the rubber

bushes from the stabiliser bar.

Refitting the rear stabiliser bar

Tightening torque

Fastening rear stabiliser bar to chassis

Fastening rear stabiliser bar - spherical tie-rod

Exhaust extension - silencer

Fastening silencer connector cross member

Undo the nuts (4) fastening the bushing bracket

(5) to the rear stabiliser bar (A).

Repeat the procedure on the left hand

Spherical clamp