Advertisement
Refitting the rear brake pads
Further separate the calliper pistons with the tool (FACOM DF.6).
Disconnect the connector (1) for the brake pad
wear sensor.
Remove the clamp (2).
Open the clamp (3) to release the pad wear
sensor cable.
Remove the pin (4), tapping with a suitable
punch and mallet.
Remove the spring (5).
Remove the pin (6), tapping with a suitable
punch and mallet.
Remove the brake pads (A).
Fit the pads (A).
Install the pin (6), tapping with a suitable punch
and mallet.
Fit the spring (5).
Install the pin (4), tapping with a suitable punch
and mallet.
Advertisement
