Advertisement
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm
fastener nuts, complete with relative
washers, each time they are removed.
Replacement is NOT necessary if the nuts
are loosened only.
Tighten the nuts indicated fastening the upper
arm (B) in the following order: (a), (b), (c), (d).
Move the shock absorber aside to facilitate the
operation.
Tightening torque
Nut (pretightening)
Nut
Attach the tie-rod for the NRRPS motion sensor
(2) to the upper arm (B).
Magnetorheological shock absorbers (optional)
only.
Check that the yellow reference markings are
correctly aligned: the markings on the stud
bolts and the markings on the Flanbloc
eyebolts must be aligned.
Nm
Class
25 Nm
A
60 Nm
A
Advertisement
