Advertisement
Fit the transmission shaft, performing the tests
and checks described as follows.
On the rear of the transmission shaft is a white
marking indicating the point of maximum
imbalance. This mark must be positioned at
approximately 180° relevant to the marking
on the transmission housing (point of
maximum flywheel imbalance).
The positions of the markings shown in the
photo aside are indicative only.
Fit the three shims (62) then snug and
subsequently fully tighten the six screws (60)
fastening the transmission shaft (61) to the
transmission housing shaft.
Proceed in a crossed pattern when both
snugging and tightening the screws to
torque.
Tighten the screws to the definitive torque with
a control angle of 90°.
Tightening torque
Screw with control angle of 90°
Move the heat shield (59) forwards.
Tighten the screws indicated.
Tightening torque
Screw
Nm
Class
60 Nm
A
Nm
Class
8 Nm
C
Advertisement
