Advertisement
Refitting the EPB electric parking brake shoes
Tightening torque
Fastening EPB Bowden cable - rear hub carrier
Fastening brake pad sensor ground cable
Release the spring (12) and remove the brake shoes (E), taking care
not to shift the linkage pins (13).
Screw
Nut
Fit the linkage (13) correctly and install the brake shoes (E) in the
respective seats, with the spring (12) already attached to one of the
shoes.
Using suitable pliers, attach the spring (12) to the other shoe (E).
Fit the lower spring (11) in the respective seat, pushing towards the
brake shoes and then turning the spring.
Fit the upper spring (10) in the respective seat, pushing towards the
brake shoes and then turning the spring.
Fit the adjuster pin (9) in its seat.
Attach the spring (8) to both brake shoes.
Check that there is a sufficient gap between the outer surfaces of the
shoes to install the brake disc without scuffing.
If the gap is insufficient, to adjust the gap between the outer surfaces of
the shoes and allow installation of the brake disc without friction,
turn the toothed sleeve on the adjuster pin (9) using a suitable
screwdriver.
Nm
Class
8 Nm
B
6 Nm
B
Advertisement
