Advertisement
Fit the hub carrier (E), fitting the axle shaft into
the relative seat on the wheel bearing.
Tighten the nut (8).
Tightening torque
Nut
Use a suitable punch and mallet to caulk (7) the
ring nut (8).
Fit the brake disc shield (D) on the hub carrier
(E).
Tighten the three screws indicated fastening the
brake disc shield (D) to the hub carrier (E).
Tightening torque
Screw
Fit the screw (5) in the relative seat after
installing the relative washer.
Fit the relative washer and, preventing the screw
(5) fastening the upper arm (C) to the hub
carrier from turning, tighten the nut (6).
Tightening torque
Nut
Fit the link (F) and the compensator ring (10) in
the relative seat on the hub carrier (E).
Apply an even layer of grease Z2 PROTECTION
to the inner surface of the compensator ring
(10) in contact with the screw head (9).
Fasten the link (F) to the hub carrier (E), fitting
and tightening the screw (9).
Tightening torque
Screw
Nm
Class
275 Nm
A
Nm
Class
9 ÷ 12 Nm
B
Nm
Class
80 Nm
A
Nm
Class
85 Nm
A
Advertisement
