Advertisement
C2.03
Refitting the complete DCT gearbox
Refitting the heat shields and the DCT gearbox struts
Tightening torque
Fastening gearbox strut heat shield
Rear mounting strut - gearbox
Products to use: AREXONS SYSTEM 52A43 -
MEDIUM STRENGTH THREAD LOCK
Front mounting strut - gearbox
Products to use: AREXONS SYSTEM 52A43 -
MEDIUM STRENGTH THREAD LOCK
Fastening axle shaft heat shield
After loosening or removal, the Caillau Visa hose clamps must be replaced with Mikalor worm drive
hose clamps, following the instructions given in Technical Information 2054 of December 2012.
With the gearbox on the workbench and supported correctly, refit the heat shields and the relevant
mounting struts as follows.
Rear right hand strut and relevant heat shield
Rear left hand strut
Screw
Screw
Screw
Screw
Fit the heat shield (2) in the relative seat on the
strut and tighten the two rear screws (red
arrows).
Tightening torque
Screw
Fit the rear right hand strut (D) in the relative
seat, apply AREXONS SYSTEM 52A43 -
MEDIUM STRENGTH THREAD LOCK on
the entire thread of the four screws indicated
(black and red arrows), then tighten the
screws in the sequence shown in the photo
aside.
Tightening torque
Screw
Tighten the two rear screws indicated (red
arrows) snugged previously.
Nm
Class
9 Nm
B
25 Nm
A
30 Nm
A
9 Nm
B
Nm
Class
9 Nm
Nm
Class
25 Nm
B
A
Advertisement
